Wall stamp 5
Name :Wall stamp mold
In advance you can broadcast your powder release agent onto the surface of the concrete stamp. Once your concrete is installed and at the concrete’s optimum degree of set you can begin stamping. (approximately the brooming stage) Place these on the surface to be stamped, and just place your seamless texture mats right over these mats. Great force should not be necessary to press the mat into the wet concrete. Since, time is of utmost importance in decorative stamping, you should begin and proceed without delay. Coat your stamp with powder release after each application. Bubble gum liquid release may be used as a substitute to the powder release. The bubble gum liquid release is a much easier and cleaner method but will leave no secondary antiquing color highlights which are achieved with the powder method. The decorative concrete should then be left to set for at least 24 hours. At the end of this period, the excess powder release (if used) should be washed off the surface of the concrete. Approximately 15-20% of the colored release agent will adhere to the concrete. Allow to dry and seal with a good quality concrete sealer. Sealer brings out the richness of the color and prevents the color from fading.